MODEL E662INTENDED FOR DOMESTIC COOKING ONLYINSTALLER: LEAVE THIS MANUAL WITH HOMEOWNER.HOMEOWNER: USE AND CARE INFORMATION ON PAGES 12 AND 13.Broan-N
- 10 -WARNINGRisk of electrical shock. Electrical wiring must be done by qualified personnel in accordance withall applicable codes and standards. Bef
- 11 -11.LIGHT BULBSThis hood must use 120V, 50W max., type MR16, GU10 shielded halogen lamps. (Purchase separately).NOTE: The rings must be removed f
- 12 -12.OPERATIONA. BLOWER OFF DELAY TOUCH PAD:When a speed is selected, touch the delay touch pad to activate the delay function. The corresponding
- 13 -13.USE AND CAREGrease filters and side panels.The grease filters and the bottom panel should be cleaned frequently. Use a warm detergent solutio
- 14 -14.WIRING DIAGRAMWARNINGRisk of electrical shock. Electrical wiring must be done by qualified personnel in accordance withall applicable codes a
- 15 -KEY PART WIDTHSno. NUMBERDESCRIPTION30’’ 36’’ 42’’15. SERVICE PARTSE662 MODELHL0056ADAPTER/DAMPERLEFT FLOW DEVIATORRIGHT FLOW DEVIATORCABINET BL
- 16 -16. WARRANTYWARRANTYBROAN-NUTONE LLC ONE-YEAR LIMITED WARRANTYBroan-NuTone LLC warrants to the original consumer purchaser of its products that
WARNING WARNING- 2 -TO REDUCE THE RISK OF FIRE, ELECTRICSHOCK OR INJURY TO PERSONS, OBSERVETHE FOLLOWING:1. Use this unit only in the manner intended
- 3 -TABLE OF CONTENTSBROAN ELITE E662 HOOD SYSTEM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .41. INS
- 4 -HL0055 Model 4157” adjustableelbow(optional)8” roundadjustableelbow(optional)BROAN ELITE E662 HOODBROAN ELITE E662HOOD SYSTEMModel 412transition
- 5 -1. INSTALL DUCTWORKPlan where and how the ductwork will be installed. Install proper-sized ductwork, elbows and roof or wall cap for the typeof b
- 6 -3. CABINET PREPARATIONWARNINGThe cabinet must be sized to support the total weight of the hood. For the E662 hood model, thetotal weight is 41 lb
- 7 -5. PREPARE THE HOOD5.1 Remove filters from the hood. Remove (3) screws holding both sidepanels to the hood and set aside. Remove both side panels
- 8 -6. INSTALL THE HOOD (CONT’D)6.3 Attach the second wire clamp, insert the power cable in the hood and tighten the wire clamp to secure the cable.
- 9 -8. INSTALL THE BLOWER IN THE CABINET8.1 Install the cabinet in the cabinet and rest it on th e adapter plate. If a framed cabinet is used, inser
Kommentare zu diesen Handbüchern